From now on, permanent vibration monitoring is no longer a question of price!
Easy to install, permanent safe mounting and free software, the Monition online system uses powerful electronics where space is extremely restricted. Each system continuously monitors machine condition, automatically evaluating the data and alerts you when damage begins to take place.
This is more than a vibration monitoring system, it not only detects vibration data, but also carries out signal analysis and machine diagnosis directly on the machine using both digital and 4-20ma signals.
The machine condition is determined and is then forwarded directly to the controllers or to the SCADA software.
The Monition online vibration monitoring system’s compatibility with data structures such as the OPC interface makes it possible to integrate condition data into a higher-level system, directly into the site PLC, SAP PM, etc.
The permanent online diagnosis of machines and equipment is the basis for a condition monitoring strategy. The integrated online analysis with up to twenty-four diagnostic characteristics makes it possible to check the conditions of monitored components at an early stage, ensuring unplanned failures are avoided.
Maintenance becomes manageable without influencing the total availability of plant. Condition characteristics such as bearing damage, unbalance, alignment or cavitation enable a differentiated evaluation of mechanical stress, the basis for selective maintenance.
All data can be transferred as binary signals or via an open data standard (OPC) to a higher level system.
Permanent Machine Protection
The permanent real-time monitoring of vibration characteristics as well as the integrated alarm interface (switching contacts/analogue signals) enable machines to be shut down before serious consequential damages arise. Turn-off times of up to 10ms can be realised. Different alarm outputs also allow sliding and differentiated alarms to the PLC level (green/yellow/red).
Root Cause Analysis
If a failure or damage occurs, the integrated trend memory makes it possible to precisely trace the damage development and its possible causes. The trending of condition characteristics and damage development are already stored in the units. This also applies to external influences such as crash, overheating, over-pressure with a real-time stamp. Up to two different input signals in addition to the vibration sensors can be connected, monitored and logged.
■ Position Sensors
■ Proximity Switches
■ Actuator Sensors
■ Photoelectric Sensors
■ Photoelectric Systems
■ Incremental and Absolute Encoders
■ Evaluation Systems
■ Power Supplies
■ Fluid Sensors and Diagnostic Systems
■ Inductive Sensors for Valves
■ Level Sensors
■ Flow Sensors
■ Pressure Sensors
■ Vacuum Sensors
■ Temperature Sensors
■ Diagnostic Systems